Application Instructions
Here is what the wall saying will look like when you get it.
There are 2 pieces, the back shiny part, and the front transfer tape.
The top transfer tape is the part the vinyl will adhere to so you can transfer it to the wall or surface.
You will then need to measure and position the wall saying on the wall or surface. Use a measuring tape and level to make sure it is level and is where you would like it. You will then need to put a couple pieces of masking tape or painters tape(a tape that will not peel your paint) and tape the whole image in place WITH THE SHINY BACKING TAPE STILL IN PLACE. At this point your image will not stick to the wall.
Next step you will want to do it to rub over the image with the enclosed squeegee to make sure the image will adhere to the top transfer tape. Then pick a corner and start to peel the transfer tape up, allowing the image to be on the top layer. Peel back half of the tape, or to the point you put your masking tape, and holding the tape up, take a pair of scissors and cut the backing paper away. The using the squeegee lay the image and tape down onto the wall or surface rubbing over gently getting rid of any bubbles.
Rub the other side again to make sure the letters adhere to the transfer tape, and repeat, but peeling the backing paper of the 2nd side.
(Note----some letters may not want to stick, so just rub them a little more and they will stick, some you have to work a little harder.)
The lay the rest of the image down on the wall or surface and go over everything again with the squeegee getting rid of any air bubbles.
Now you are ready to peel the transfer tape off to show the image! Start peeling from one corner at an angle leaving the image on the surface. On some lightly textured surfaces, you may need to go very slow and rub harder for the letters to stick.
Enjoy your wall saying!!!
Enjoy your wall saying!!!
Featured Products
No featured products